Dynamic Friction Company Disc Brake Hardware Kit P/N:340-58004

Be the first to review this product
$7.99
MPN: 340-58004
UPC: 190920005367
Item Package Quantity: 1
Adding to cart… The item has been added

Have questions?

Dynamic Friction Company Disc Brake Hardware Kit P/N:340-58004
Dynamic Friction Company Disc Brake Hardware Kit P/N:340-58004
$7.99

Keep your front brakes seated tight and rattle-free with the Dynamic Friction Company Disc Brake Hardware Kit (P/N 340-58004, also written 34058004). This disc brake hardware kit drops in as a direct-fit replacement for the front brakes on the 2005-2012 Acura RL — see the Buyer's Guide tab for the full engine-level fitment. Refreshing the clips, springs and mounting hardware every time you install new pads helps the pads slide freely, seat squarely and stay quiet.

  • Corrosion resistance: designed to resist rust so hardware keeps its spring tension and doesn't seize over time.
  • High heat resistance: built to hold up to the elevated temperatures at the brake caliper and pad interface.
  • Chemical resistance: intended to stand up to brake fluid, road salt and cleaners without degrading.
  • Low coefficient of friction & easy assembly: lets the pads move smoothly in the caliper bracket for consistent, even wear and straightforward install and removal.

Replacing worn or corroded hardware alongside a fresh pad set is a smart practice — old clips lose tension and can cause noise, uneven pad wear or a stuck pad. Fit this kit to the front axle of the listed Acura RL for a clean, straightforward install.

Frequently Asked Questions

What vehicles does this hardware kit fit?

It is a direct-fit front disc brake hardware kit for the 2005-2012 Acura RL. Check the Buyer's Guide tab to confirm the exact fit for your vehicle.

Which axle is this kit for?

This kit is cataloged for the FRONT brakes. It supplies the clips, springs and mounting hardware for the front disc brakes on the listed Acura RL.

What is included in P/N 340-58004?

It includes the disc brake hardware — the clips, springs and mounting pieces used to install and retain the front brake pads. Refer to the listing images and the manufacturer's contents for exact components.

Do I need to replace the hardware when I change my brake pads?

It is a smart practice. Old clips lose spring tension and can corrode, which may cause noise, uneven pad wear or a sticking pad, so fresh hardware helps the new pads seat and slide correctly.

What makes this hardware resistant to wear?

It is designed for corrosion, chemical and high-heat resistance, so it holds tension and resists rust from brake heat, fluid and road salt. Its low coefficient of friction also helps the pads move freely.