Dynamic Friction Company Disc Brake Hardware Kit P/N:340-58006

Be the first to review this product
$8.99
MPN: 340-58006
UPC: 190920005381
Item Package Quantity: 1
Adding to cart… The item has been added

Have questions?

Dynamic Friction Company Disc Brake Hardware Kit P/N:340-58006
Dynamic Friction Company Disc Brake Hardware Kit P/N:340-58006
$8.99

Keep your rear disc brakes seated, quiet, and moving freely with the Dynamic Friction Company Disc Brake Hardware Kit 340-58006. This rear hardware kit installs as a direct-fit replacement for the 2014-2020 Acura RLX, 2015-2020 Acura TLX, 2016 Honda CR-Z, and 2016-2022 Honda HR-V — see the Buyer's Guide tab for engine-level fitment. Fresh hardware restores proper pad positioning and takes up the play that worn, corroded clips and springs leave behind.

Highlights from DFC:

  • Corrosion & chemical resistance: holds up against road salt, moisture, and brake chemicals.
  • High heat resistance: designed to withstand the temperatures generated at the rear brakes.
  • Low coefficient of friction: helps the pads slide smoothly on the abutment surfaces.
  • Easy assembly & removal: intended to speed up the pad service.

Replacing this hardware whenever you install new rear pads is good practice — reusing stretched clips and springs can allow uneven pad movement, noise, and drag. If worn or rusted rear brake hardware is behind your noise or uneven pad wear, this disc brake hardware kit provides the fresh clips and springs to address it. Always confirm the rear pads move freely after installation.

Frequently Asked Questions

What is included in this kit?

It supplies the rear disc brake hardware — the clips and springs that position and retain the brake pads. Refer to the product listing for the exact contents for your application.

Does this fit my vehicle?

It is a direct-fit replacement for the 2014-2020 Acura RLX, 2015-2020 Acura TLX, 2016 Honda CR-Z, and 2016-2022 Honda HR-V. Check the Buyer's Guide tab to confirm your exact vehicle.

Is this for the front or rear brakes?

This is a rear disc brake hardware kit, cataloged for the rear position on the listed applications.

Should I replace the hardware with new pads?

Replacing brake hardware alongside new pads is recommended. Worn or corroded clips and springs can cause noise, drag, and uneven pad wear even with fresh pads.

Will this stop my brake noise?

If worn or rusted rear hardware is the cause of noise or uneven pad movement, fresh hardware helps address it. Diagnose the source first, since noise can have other causes.