Keep your front brakes clamping cleanly and quietly with the Dynamic Friction Company Disc Brake Hardware Kit (P/N 340-59028, also written 34059028). This front brake hardware kit drops in as a direct-fit replacement for the 2000-2006 Honda Insight, refreshing the clips, springs, and small hardware that locate the pads and keep them moving freely in the caliper.
Fresh hardware is what quiets rattles and helps the pads slide evenly, so it's worth replacing whenever you install new pads.
Worn or rusted hardware can let pads bind or rattle, causing noise and uneven pad wear; if that hardware is the cause, this kit replaces it. Fits the 2000-2006 Honda Insight — see the Buyer's Guide tab to confirm your vehicle.
What vehicle does this hardware kit fit?
It's a direct-fit front brake hardware kit for the 2000-2006 Honda Insight. Check the Buyer's Guide tab to confirm the fit for your specific vehicle.
Is this a front or rear kit?
This is a front brake hardware kit, covering the clips, springs, and small hardware at the front brakes.
When should I replace the brake hardware?
It's best practice to install fresh hardware whenever you fit new brake pads, since worn or corroded clips can let pads bind, rattle, or wear unevenly.
What does the brake hardware actually do?
The clips and springs locate the pads in the caliper and keep them sliding freely, which helps quiet rattles and promotes even pad movement and wear.
Can bad hardware cause brake noise?
Yes. Worn or rusted hardware can let the pads rattle or bind, causing noise and uneven wear. If that hardware is the cause, this kit replaces it.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
