Keep your front disc brakes quiet, aligned, and moving freely with the Dynamic Friction Company Disc Brake Hardware Kit (P/N 340-63005). This front-position kit supplies the fresh clips, springs, and small hardware that locate the pads and let them slide as designed — the pieces that fatigue, corrode, and lose tension over years of heat cycling and are best renewed whenever the brakes are serviced. It's a direct-fit replacement for a wide range of classic Mercedes-Benz models; see the fitment list and the Buyer's Guide tab for engine specifics.
Installing new hardware alongside pads helps promote even pad wear and consistent, rattle-free braking. This disc brake hardware kit fits the following applications:
What is included in this disc brake hardware kit?
It supplies the front disc brake hardware — the clips, springs, and small fasteners that locate the pads and let them slide as designed. Refer to the manufacturer's kit contents for the exact pieces for your application.
Does this kit fit the front or rear brakes?
This is a front-position disc brake hardware kit for the listed Mercedes-Benz applications.
Should I replace brake hardware when I change pads?
Yes, it's good practice. Clips and springs lose tension and corrode over time, so fitting new hardware with new pads helps promote even wear and consistent, rattle-free braking.
Will this fit my Mercedes-Benz?
It's a direct-fit replacement for the listed models, including the 350SL, 280SE, 280SEL, 450SE, 450SEL, 450SL, 450SLC, 300SD, and 560SL. Check the fitment list and Buyer's Guide tab to confirm your year and model.
What features does this hardware offer?
Dynamic Friction lists corrosion resistance, high heat resistance, chemical resistance, a low coefficient of friction, and easy assembly and removal.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
