Keep your front brake pads properly located, retained, and rattle-free with the Dynamic Friction Company Brake Hardware Kit (MPN 340-63013, also written 34063013). It fits a wide range of classic European applications, including the 1963-1965 Mercedes-Benz 190C, the 1968-1973 Mercedes-Benz 250, the 1969-1974 Alfa Romeo Spider, the 1976 Porsche 912, and the 1970-1972 Volkswagen Transporter — see the Buyer's Guide tab for the full list of 32 applications.
This kit supplies the small clips, springs, and hardware that position and secure the pads at the front disc brakes, so the pads seat correctly and move freely as they wear. Refreshing this hardware whenever you install new pads helps restore quiet, consistent brake operation.
Engineered for easy assembly and removal during a pad service.
What is this disc brake hardware kit for?
It provides the clips, springs, and hardware that locate and retain the front disc brake pads, helping them seat correctly and move freely as they wear.
Which position does this kit fit?
It is a front-position brake hardware kit for the listed applications. Confirm your vehicle in the Buyer's Guide tab.
Does this fit my vehicle?
It fits 32 classic applications, including the 1963-1965 Mercedes-Benz 190C, 1968-1973 Mercedes-Benz 250, 1969-1974 Alfa Romeo Spider, and 1976 Porsche 912. Check the Buyer's Guide tab for the full list.
Should I replace the hardware when I install new pads?
Refreshing the hardware with each pad service is good practice, since worn or corroded clips and springs can cause noise and uneven pad movement.
What features does this kit offer?
It offers corrosion resistance, chemical resistance, and high heat resistance, plus a low coefficient of friction and easy assembly and removal during a pad service.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
