Keep your front brakes quiet, freely moving, and correctly located with the Dynamic Friction Company Disc Brake Hardware Kit 340-63017. This front hardware kit installs on the 1998-2003 Mercedes-Benz ML320, the 2003-2005 Mercedes-Benz ML350, and the 1999 Mercedes-Benz ML430 (see the Buyer's Guide tab for engine details), refreshing the small clips, springs, and abutment pieces that position the pads and let them slide freely against the rotor.
Whenever you fit new pads, replacing this worn hardware helps the pads seat and retract properly, which supports even wear and consistent pad movement.
Fresh hardware is inexpensive insurance against noise, uneven wear, and sticking pads, so this disc brake hardware kit is a smart addition to any front pad job on these Mercedes-Benz M-Class models.
What vehicles does the 340-63017 hardware kit fit?
It fits the front brakes of the 1998-2003 Mercedes-Benz ML320, 2003-2005 Mercedes-Benz ML350, and 1999 Mercedes-Benz ML430. Check the Buyer's Guide tab to confirm your vehicle.
What is a disc brake hardware kit?
It's the set of clips, springs, and abutment pieces that position the brake pads and let them slide freely against the rotor. Fresh hardware helps the pads move and retract properly.
Should I replace the hardware when I install new pads?
It's good practice. Worn or corroded hardware can cause noise, sticking, and uneven wear, so installing new hardware with new pads helps them seat and slide correctly.
Is this a front or rear kit?
This kit is cataloged for the front brakes on the listed Mercedes-Benz M-Class applications.
Can this hardware handle brake heat and road chemicals?
Yes. It's built for high heat resistance during braking and offers corrosion and chemical resistance against road spray, brake dust, and cleaners.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
