Keep your rear disc brakes properly seated and functioning smoothly with the Dynamic Friction Company Brake Hardware Kit 340-63042 (also written 34063042). This rear-position hardware kit installs with a new set of brake pads on the 2001-2005 Mercedes-Benz A190 and the 2006-2011 Mercedes-Benz B200, supplying the clips, springs and hardware that locate and retain the pads and help control noise and vibration as the brakes are applied.
Fresh hardware is recommended whenever the pads are replaced, since worn or corroded clips can let pads sit unevenly or rattle.
If worn rear brake hardware is the cause of pad rattle, uneven wear or squeal, this disc brake hardware kit replaces it.
What vehicles does this hardware kit fit?
It is a direct-fit rear brake hardware kit for the 2001-2005 Mercedes-Benz A190 and the 2006-2011 Mercedes-Benz B200. See the Buyer's Guide tab to confirm your vehicle.
Is this for the front or rear brakes?
This is a rear-position brake hardware kit for the listed applications.
Should I replace the hardware when I change my pads?
Fresh hardware is recommended with every pad replacement. Worn or corroded clips and springs can cause pads to rattle, sit unevenly, or wear improperly.
What does a brake hardware kit do?
It supplies the clips, springs and hardware that locate and retain the brake pads, helping control noise and vibration and letting the pads move as intended during braking.
Can this fix a rear brake rattle or squeal?
If worn or corroded rear brake hardware is the cause of the rattle, uneven pad wear or squeal, replacing it with this kit addresses it. Diagnose the cause before ordering.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
