Keep your front brakes quiet and clamping evenly with the Dynamic Friction Company Disc Brake Hardware Kit (P/N 340-63057). This front-position disc brake hardware kit supplies the fresh clips, springs and small hardware that locate the pads and keep them moving freely in the caliper — the pieces best replaced whenever you install new pads. It's a direct-fit replacement for a range of Mercedes-Benz cars, including the 2004-2005 C230, 2002-2004 C32 AMG, 2003-2005 C320, 2003-2006 CL500, 2006 E350, 2003-2006 E500, 2006 S350, 2003-2006 S430, 2005-2006 SL500, and the S500 in 2002-2003 and again in 2005-2006.
Refreshing worn or rusted hardware helps address pad rattle, uneven pad wear and sticking pads when tired clips are the cause. See the Buyer's Guide tab for the full engine-level application list.
What is a disc brake hardware kit?
It's the set of clips, springs and small hardware that locate the brake pads and let them slide freely in the caliper. Replacing it with new pads helps keep braking quiet and even.
Does this kit fit the front or rear brakes?
This kit is cataloged for the FRONT brake position on the listed Mercedes-Benz applications.
Which vehicles does P/N 340-63057 fit?
It fits select Mercedes-Benz models including the C230, C32 AMG, C320, CL500, E350, E500, S350, S430, S500 and SL500. Check the Buyer's Guide tab for exact years and engines.
Should I replace the hardware when I install new pads?
Yes, it's good practice. Fresh clips and springs help the new pads seat and slide correctly, reducing the chance of rattle, sticking and uneven wear.
Can worn hardware cause brake noise?
It can. Rusted or fatigued clips may let pads rattle or bind. If failed hardware is the cause of your noise or uneven wear, this kit replaces those pieces.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
