Dynamic Friction Company Disc Brake Hardware Kit 340-63061

Dynamic Friction Company Disc Brake Hardware Kit P/N:340-63061

Be the first to review this product

$8.99

MPN: 340-63061

UPC: 190920006470

Item Package Quantity: 1

Current Stock:

Quantity:

Adding to cart… The item has been added

Have questions?

Ask an Expert

Dynamic Friction Company Disc Brake Hardware Kit P/N:340-63061

$8.99

Description

Keep your rear disc brakes seated, quiet, and moving freely with the Dynamic Friction Company Disc Brake Hardware Kit (P/N 340-63061, also written 34063061). This rear brake hardware kit drops in as a direct-fit replacement for the 2014-2015 Mercedes-Benz B Electric Drive and the 2014-2019 Mercedes-Benz CLA250 — see the Buyer's Guide tab for engine-level details.

Fresh hardware renews the clips and springs that locate the pads and let them slide as designed. Replacing these small parts whenever you install new pads helps address the noise, uneven pad wear, and dragging that can follow tired, corroded hardware.

Corrosion & chemical resistance: built to hold up against road salt, moisture, and brake-service chemicals.
High heat resistance: designed to withstand the temperatures generated at the rear brakes.
Low coefficient of friction: intended to let the pads slide smoothly against the hardware.
Easy assembly & removal: made for straightforward installation during a routine pad job.

DFC recommends fitting fresh hardware every time the rear pads are replaced for consistent, balanced braking.

Manufacturer's Description

Product Specs

Buyer's Guide

Interchange Part Numbers

Frequently Asked Questions

What is a disc brake hardware kit?

It is the set of clips, springs, and abutment pieces that locate the rear disc brake pads and let them slide freely. Replacing them with new pads helps keep braking quiet and even.

Which vehicles does P/N 340-63061 fit?

It is a direct-fit replacement for the 2014-2015 Mercedes-Benz B Electric Drive and the 2014-2019 Mercedes-Benz CLA250. Check the Buyer's Guide tab to confirm your vehicle.

Is this for the front or rear brakes?

This kit is for the rear disc brakes.

Should I replace the hardware when I install new pads?

Yes. DFC recommends fitting fresh hardware with every pad replacement so the pads seat and slide correctly for consistent, balanced braking.

Can worn hardware cause brake noise?

Corroded or fatigued hardware can contribute to noise, dragging, and uneven pad wear. If failed hardware is the cause, this kit replaces it, but diagnose the source before servicing.