Keep your rear disc brakes clamping quietly and evenly with the Dynamic Friction Company Disc Brake Hardware Kit (P/N 340-67026, also written 34067026). This rear-position hardware kit drops in as a direct-fit replacement for the 2008-2013 Nissan Rogue — see the Buyer's Guide tab for engine-level details. Fresh hardware helps restore the correct pad movement and retention that worn, rusted clips and springs can no longer provide.
Replacing the clips, springs, and abutment hardware whenever you install new rear pads helps promote quiet, even braking and reduces the risk of stuck pads and uneven wear. This is a smart addition to any rear disc brake job on the listed Rogue applications.
What is this Dynamic Friction 340-67026 kit?
It is a rear disc brake hardware kit — the clips, springs, and abutment hardware that locate and retain the brake pads. It replaces worn or corroded factory hardware during a rear brake service.
What vehicles does P/N 340-67026 fit?
It is a direct-fit replacement for the 2008-2013 Nissan Rogue. See the Buyer's Guide tab to confirm the exact application for your vehicle.
Is this front or rear hardware?
This kit is cataloged for the REAR position on the listed Nissan Rogue applications.
Why replace brake hardware with new pads?
Clips and springs lose tension and corrode over time, which can cause stuck pads, noise, and uneven wear. Fresh hardware helps the new pads slide and seat properly for even braking.
Does this kit include brake pads?
No. This is a hardware kit containing the clips, springs, and abutment hardware only. Brake pads are sold separately.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
