Keep your front brake pads seated, quiet, and moving freely with the Dynamic Friction Company Disc Brake Hardware Kit (P/N 340-67037, also written 34067037). It installs on the 2007-2017 Nissan Tiida and 2009-2011 Nissan Versa — see the Buyer's Guide tab for full engine-level fitment.
A brake hardware kit supplies the small clips and springs that locate and retain the disc brake pads in the caliper bracket, keeping them properly positioned so they slide and retract as designed. Fresh hardware is the standard companion to a pad replacement, since worn or corroded clips can let pads rattle, bind, or wear unevenly.
Built for easy assembly and removal to keep your brake service straightforward.
What does this disc brake hardware kit do?
It supplies the clips and springs that locate and retain the disc brake pads in the caliper bracket, keeping them properly positioned so they slide and retract as designed.
Which vehicles does P/N 340-67037 fit?
It fits the 2007-2017 Nissan Tiida and the 2009-2011 Nissan Versa. Check the Buyer's Guide tab to confirm the exact fitment for your vehicle.
Is this a front or rear kit?
This is a front brake hardware kit for the listed applications.
Should I replace the hardware when I install new pads?
Fresh hardware is the standard companion to a pad replacement. Worn or corroded clips can let pads rattle, bind, or wear unevenly, so replacing it during a brake job is good practice.
Why does the hardware have corrosion and heat resistance?
The kit is designed with corrosion, chemical, and high heat resistance to stand up to road spray, brake chemicals, and the temperatures generated at the brake.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
