Keep your front brake pads properly located and sliding freely with the Dynamic Friction Company Disc Brake Hardware Kit 340-68008. This front disc brake hardware kit installs on the 2007-2008 Infiniti G35, 2008-2013 Infiniti G37, and 2014-2015 Infiniti Q60 — see the Buyer's Guide tab for the full engine-level fitment. Whenever pads are serviced, fresh hardware helps the pads seat correctly in the caliper and move as the brakes apply and release.
Reusing worn, corroded, or distorted clips and retainers can leave pads binding or rattling, so replacing the hardware alongside the pads is good practice. This kit covers the front position on the listed applications.
What does this disc brake hardware kit do?
It supplies the front brake hardware that positions the disc brake pads in the caliper and lets them slide freely as the brakes apply and release.
Which vehicles does the 340-68008 kit fit?
It fits the 2007-2008 Infiniti G35, 2008-2013 Infiniti G37, and 2014-2015 Infiniti Q60. Check the Buyer's Guide tab to confirm your exact vehicle.
Is this a front or rear hardware kit?
This is a front disc brake hardware kit for the listed Infiniti applications.
When might I need to replace the brake hardware?
Signs the hardware may need replacing include rattling or clicking from the brakes, pads that bind rather than slide freely, and corroded or distorted clips.
Should I install new hardware with new brake pads?
Replacing the hardware whenever you fit new pads is good practice, since fresh clips and retainers help the pads seat and move properly.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
