Keep your rear disc brakes seated, quiet, and moving freely with the Dynamic Friction Disc Brake Hardware Kit 340-72008. This rear-position hardware kit installs as a direct-fit replacement for the 2003-2006 Mitsubishi Lancer, refreshing the clips, springs, and abutment hardware that locate the pads and let them slide as designed. Replacing worn or corroded hardware whenever you fit new pads helps promote even pad movement and consistent contact with the rotor.
If binding, rattling, or uneven pad wear traces back to tired brake hardware, this kit replaces those worn pieces during a rear brake service. For the exact engine applications this kit covers, see the Buyer's Guide tab.
What vehicles does this hardware kit fit?
It is a direct-fit replacement for the 2003-2006 Mitsubishi Lancer. Check the Buyer's Guide tab to confirm the exact engine application for your vehicle.
Is this a front or rear brake hardware kit?
This is a rear-position disc brake hardware kit, supplying the clips and hardware for the rear disc brakes on the listed applications.
What comes in this kit?
It supplies the disc brake hardware — the clips, springs, and abutment pieces that locate the pads and let them slide. It does not include brake pads or rotors.
Should I replace the hardware when I install new pads?
Yes, it's good practice. Fresh hardware helps promote even pad movement and consistent rotor contact, and worn or corroded clips can cause binding or rattling.
Can worn brake hardware cause noise or uneven pad wear?
It can. If binding, rattling, or uneven pad wear traces back to worn or corroded hardware, replacing it with this kit addresses that hardware during a rear brake service.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
