Keep your front disc brakes quiet and properly located with the Dynamic Friction Company Disc Brake Hardware Kit 340-72009. This front-position brake hardware kit supplies the small parts that position and retain the pads and caliper components, and it drops in as a direct-fit replacement for the 2006-2009 Land Rover Range Rover, the 2006-2009 Land Rover Range Rover Sport, and the Mitsubishi Lancer in both 2003-2006 and 2008-2015 model years. See the Buyer's Guide tab for engine-level fitment.
When you're already replacing pads, fresh hardware helps the pads seat and slide the way they should:
If worn, corroded, or missing clips and hardware are contributing to brake noise or uneven pad wear, this kit replaces those pieces during a front brake service.
What is this part?
It is a Dynamic Friction Company disc brake hardware kit (MPN 340-72009) for the front position. It supplies the clips and small parts that position and retain the disc brake pads and caliper components.
Which vehicles does the 340-72009 fit?
It is a direct-fit replacement for the 2006-2009 Land Rover Range Rover, 2006-2009 Range Rover Sport, and the 2003-2006 and 2008-2015 Mitsubishi Lancer. Check the Buyer's Guide tab for engine-level fitment.
Should I replace the hardware when I change my brake pads?
It's good practice. Fresh hardware helps the new pads seat, slide, and retain correctly. Worn or corroded clips can contribute to noise and uneven pad wear.
What benefits does this hardware kit offer?
It's designed for corrosion, heat, and chemical resistance, with a low coefficient of friction to help pads move freely, plus easy assembly and removal during install.
Is this a front or rear kit?
This is a front-position brake hardware kit for the listed applications.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
