Keep your rear brakes quiet, properly clamped, and easy to service with the Dynamic Friction Company Disc Brake Hardware Kit (P/N 340-72010, also written 34072010). This kit is a direct-fit replacement for the rear disc brakes on the 2008-2015 Mitsubishi Lancer — see the Buyer's Guide tab for engine-level fitment. Replacing the small clips, springs, and abutment hardware whenever you install new pads helps the pads seat, slide, and retract the way the brake system intends.
Fresh hardware is inexpensive insurance against uneven pad wear, rattles, and stuck pads that fatigued clips can cause. Install it alongside a new set of rear pads for consistent, balanced braking on the listed Lancer applications.
What vehicles does this hardware kit fit?
It is a direct-fit replacement for the rear disc brakes on the 2008-2015 Mitsubishi Lancer. Check the Buyer's Guide tab to confirm your specific engine and trim.
What is included in this brake hardware kit?
These kits supply the clips, springs, and abutment hardware for the rear disc brakes. See the product images and Buyer's Guide for the exact contents for your application.
Do I need to replace the hardware every time I do a brake job?
It is recommended. Fresh clips and springs help the pads slide and retract properly, which supports even wear and quieter braking versus reusing fatigued original hardware.
Which axle is this kit for?
This kit is for the rear disc brakes on the listed Mitsubishi Lancer applications.
Can worn brake hardware cause noise or uneven pad wear?
Yes. Corroded or fatigued clips can let pads stick or rattle, which may lead to uneven wear. If worn hardware is the cause, replacing it with this kit addresses it.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
