Dynamic Friction Company Disc Brake Hardware Kit P/N:340-76008

Be the first to review this product
$9.99
MPN: 340-76008
UPC: 190920008153
Item Package Quantity: 1
Adding to cart… The item has been added

Have questions?

Dynamic Friction Company Disc Brake Hardware Kit P/N:340-76008
Dynamic Friction Company Disc Brake Hardware Kit P/N:340-76008
$9.99

Keep your rear brakes seated and moving freely with the Dynamic Friction Company Brake Hardware Kit 340-76008 (also written 34076008). This rear disc brake hardware kit drops in as a direct-fit replacement for the 1995-1999 Toyota Avalon, refreshing the clips, springs, and mounting hardware that locate the brake pads and let them slide and retract as designed. Fresh hardware is a smart companion whenever you install new pads, since worn or corroded clips are a common source of noise and uneven pad movement.

Corrosion resistance: built to resist rust and the road-salt exposure that seizes old hardware.
High heat resistance: holds up to the temperatures generated at the brakes.
Chemical resistance: stands up to brake fluid, cleaners, and other underbody chemicals.
Low coefficient of friction: helps the pads slide smoothly against the abutment surfaces.

Designed for easy assembly and removal, this kit helps address squeal, rattle, and sticking pads when worn hardware is the cause. For the engine covered on your Avalon, see the Buyer's Guide tab for the full application list.

Frequently Asked Questions

What vehicle does the 340-76008 hardware kit fit?

It is a direct-fit replacement for the 1995-1999 Toyota Avalon. See the Buyer's Guide tab to confirm the engine and application for your specific vehicle.

Is this a front or rear brake hardware kit?

This is a rear disc brake hardware kit, containing the clips, springs, and mounting hardware for the rear brakes on the listed Avalon applications.

What does a brake hardware kit do?

It supplies the clips, springs, and mounting hardware that position the brake pads and allow them to slide and retract properly, which helps keep braking quiet and even.

Should I replace the hardware when I install new pads?

It is good practice. Worn or corroded clips and springs are a common cause of noise and sticking pads, so fresh hardware helps your new pads move and seat correctly.

Will this kit stop my brake squeal or rattle?

If worn or corroded hardware is the cause, replacing it helps address squeal, rattle, and sticking pads. Diagnose the noise first, as other brake components can also be responsible.