Keep your rear brakes clamping quietly and evenly with the Dynamic Friction Company Disc Brake Hardware Kit (P/N 340-76027, also written 34076027). This rear disc brake hardware kit is a direct-fit replacement for the 1985-1989 Toyota MR2, supplying the clips, springs, and small hardware that locate the pads and keep them moving freely during every stop.
Worn or corroded hardware can allow rattles, uneven pad wear, and pads that stick and drag — the original clips lose tension and corrode over years of heat cycling, so replacing them with a service is smart practice whenever you fit new pads.
For the correct engine applications on your 1985-1989 Toyota MR2, see the Buyer's Guide tab.
What vehicle does this hardware kit fit?
It is a direct-fit replacement for the 1985-1989 Toyota MR2. Check the Buyer's Guide tab to confirm the exact engine application for your vehicle.
Is this a front or rear brake hardware kit?
This is a rear disc brake hardware kit, supplying the clips, springs, and small hardware for the rear brakes.
What comes in this kit?
It provides the clips, springs, and small mounting hardware that locate the disc brake pads and let them move freely. It does not include brake pads.
Should I replace the hardware when I install new pads?
Yes, it is good practice. Old clips lose tension and corrode over time, which can cause rattles, drag, and uneven pad wear, so fresh hardware is recommended with every pad service.
What features does this DFC hardware offer?
It offers corrosion, chemical, and high-heat resistance, plus a low coefficient of friction and easy assembly and removal for smooth pad movement during installation and use.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
