Rear Brake Hardware Kit for 1997-1999 Toyota Camry & More - Dynamic Friction 340-76031

Be the first to review this product
$8.99
MPN: 340-76031
UPC: 190920008375
Item Package Quantity: 1
Adding to cart… The item has been added

Have questions?

Dynamic Friction Company Disc Brake Hardware Kit P/N:340-76031
Dynamic Friction Company Disc Brake Hardware Kit P/N:340-76031
$8.99

Help your rear disc brake pads stay properly located and slide freely with the Dynamic Friction Company Brake Hardware Kit, part number 340-76031. It fits many vehicles, among them the 1997-1999 Toyota Camry, 1998-1999 Toyota Celica and 1999 Toyota Solara. See the Buyer's Guide tab for the full list.

Brake hardware sits between the pads and the caliper bracket, where heat, moisture and road grime reach it on every stop. When the original pieces corrode or wear, new hardware is a common part of a rear brake service. DFC lists these features for this kit:

  • High heat resistance: designed to resist the high temperatures generated at the brakes.
  • Corrosion and chemical resistance: intended to resist corrosion and the chemicals the brake area is exposed to.
  • Low coefficient of friction: helps the pads move smoothly in the bracket as the brakes apply and release.
  • Easy assembly and removal: made to go on and come off easily during a brake job.

Signs the rear brake hardware may need replacing include pad rattle, brake squeal, uneven pad wear, or pads that seem to stick. These symptoms can have other causes, so inspect the brakes before replacing parts. Many technicians install a fresh disc brake hardware kit whenever they replace the pads, and the vehicle service information gives the correct installation procedure.

Frequently Asked Questions

Is this the right brake hardware kit for a 1997-1999 Toyota Camry?

It is listed for the rear brakes of the 1997-1999 Toyota Camry. Check your exact vehicle in the Buyer's Guide tab before ordering.

What does a brake hardware kit do?

It holds the brake pads in position in the caliper bracket and lets them slide as the brakes apply and release, which also helps limit pad rattle.

What features does DFC list for part 340-76031?

DFC lists high heat resistance, corrosion resistance, chemical resistance, a low coefficient of friction, and easy assembly and removal.

What are signs my rear brake hardware may need replacing?

Pad rattle, squeal, uneven pad wear or pads that seem to stick can point to worn hardware. These can have other causes, so inspect the brakes first.

Should I replace the brake hardware when I change the pads?

Many technicians renew the hardware during a pad replacement because old pieces can corrode or wear. Follow the vehicle service information for the correct installation.