Keep your front disc brakes quiet, correctly seated, and squeak-free with the Dynamic Friction Company Brake Hardware Kit (P/N 340-76080). This front disc brake hardware kit is a direct-fit replacement for the 1984-1985 Toyota 4Runner and the 1979-1985 Toyota Pickup — see the Buyer's Guide tab for engine details on the listed applications. It refreshes the small but critical clips, springs, and abutment hardware that locate the pads and control their movement, restoring the crisp, rattle-free operation worn or corroded hardware can no longer provide.
Replacing this hardware alongside your pads is best practice — worn clips and springs are a common source of brake noise, uneven pad wear, and binding. Install this front hardware kit whenever the pads are serviced for proper, balanced brake function.
What does this brake hardware kit do?
It supplies the clips, springs, and abutment hardware that locate the front disc brake pads and control their movement, helping keep them properly seated and quiet.
Which vehicles does P/N 340-76080 fit?
It is a direct-fit front replacement for the 1984-1985 Toyota 4Runner and the 1979-1985 Toyota Pickup. Check the Buyer's Guide tab to confirm your vehicle.
Is this for the front or rear brakes?
This is a front disc brake hardware kit, cataloged for the front position on the listed applications.
Should I replace the hardware when I change my pads?
Yes — replacing worn clips and springs alongside new pads is best practice, since aged hardware is a common cause of noise, uneven pad wear, and binding.
What are the signs this hardware may need replacing?
Brake noise such as rattling or squeal, uneven pad wear, or pads that bind or don't move freely can indicate worn or corroded hardware.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
