Keep your front brakes seated, quiet, and moving freely with the Dynamic Friction Company Disc Brake Hardware Kit (P/N 340-80015). This front disc brake hardware kit is a direct-fit replacement for the 1986-1991 Mazda RX-7 — see the Buyer's Guide tab for engine-level fitment. The small clips, springs, and abutment hardware in a brake job are what locate the pads, control rattle, and let the pads slide as they wear, so refreshing them with every pad change helps the new pads seat and release the way they should.
If worn or rusted hardware is behind your brake noise or uneven pad movement, replacing it with this front kit addresses that.
What is this part?
It is a Dynamic Friction Company front disc brake hardware kit (P/N 340-80015) containing the clips, springs, and abutment hardware that locate the pads and control noise at the front brakes.
Does it fit my vehicle?
It is a direct-fit replacement for the 1986-1991 Mazda RX-7. See the Buyer's Guide tab for engine-level fitment.
Why replace the brake hardware?
Clips and springs lose tension and corrode over time. Fresh hardware helps the pads seat, slide, and release correctly, which addresses rattle and uneven pad movement caused by worn hardware.
Should I replace hardware with every brake job?
Replacing the hardware alongside new pads is good practice, since it helps the new pads seat and move freely rather than reusing fatigued clips and springs.
What are the features of this kit?
It offers corrosion resistance, high heat resistance, chemical resistance, a low coefficient of friction for smooth pad movement, and easy assembly and removal.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
