Keep your rear disc brakes quiet and properly seated with the Dynamic Friction Company Disc Brake Hardware Kit (P/N 340-80029, also written 34080029). This DFC brake hardware kit installs at the rear brakes as a direct-fit replacement for the 2001-2005 Mazda Miata, refreshing the small clips, springs and retainers that locate the pads and keep them moving freely during every stop. See the Buyer's Guide tab for engine-level fitment.
Worn, rusted or missing brake hardware can cause noise, dragging pads and uneven pad wear. Replacing the clips and springs with fresh hardware whenever you service the rear pads helps restore proper pad movement and consistent contact. If failed hardware is the cause of your rear brake noise or drag, this kit replaces it.
What is this Dynamic Friction disc brake hardware kit?
It's a DFC rear disc brake hardware kit (P/N 340-80029) containing the clips, springs and retainers that locate the brake pads and keep them moving freely at the rear brakes.
Does this fit my vehicle?
It's a direct-fit replacement for the 2001-2005 Mazda Miata rear brakes. Check the Buyer's Guide tab to confirm the application for your vehicle.
Should I replace brake hardware when I install new pads?
Yes, replacing the hardware with fresh clips and springs during a pad service is good practice, helping restore proper pad movement and consistent contact.
Which brake position does this kit cover?
This kit is for the rear disc brakes on the listed applications.
What are signs the brake hardware may need replacing?
Worn, rusted or missing hardware can cause brake noise, dragging pads and uneven pad wear. If faulty hardware is the cause, this kit replaces it.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
