Keep your front pads properly located and retained with the Dynamic Friction Company Disc Brake Hardware Kit 340-80034 (also written 34080034). This front-axle hardware kit is a direct-fit replacement for the 2013-2025 Mazda CX-5 — see the Buyer's Guide tab for the engine-level applications. When you install fresh pads, refreshing the hardware helps the pads seat, slide, and retain the way the brake system was designed to work.
A disc brake hardware kit supplies the clips and retaining hardware that position the pads at the front caliper and keep them held securely during braking.
The kit is engineered for easy assembly and removal, making it a straightforward addition to a front brake job. Replacing worn or rusted hardware alongside new pads helps promote quiet, even braking on your Mazda CX-5.
What vehicles does the 340-80034 hardware kit fit?
It's a direct-fit replacement for the front axle of the 2013-2025 Mazda CX-5. See the Buyer's Guide tab for the engine-level applications.
What is a disc brake hardware kit for?
It supplies the clips and retaining hardware that position the brake pads at the caliper and hold them securely during braking, helping the pads seat and slide correctly.
Is this hardware kit for the front or rear brakes?
This kit is cataloged for the front axle of the listed Mazda CX-5 applications.
Should I replace brake hardware when I install new pads?
Refreshing worn or corroded hardware with new pads helps the pads seat and slide properly, promoting quiet, even braking. It's a common step during a brake job.
Can this hardware resist heat and corrosion?
Yes. Dynamic Friction lists this kit with high heat resistance, corrosion resistance, and chemical resistance, plus a low coefficient of friction for smooth pad movement.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
