Keep your rear brakes seated, quiet, and moving freely with the Dynamic Friction Company Disc Brake Hardware Kit 340-80035. This rear disc brake hardware kit is a direct-fit replacement for the 2016-2018 Mazda CX-3 and the 2013-2015 Mazda CX-5, supplying fresh clips, springs, and related hardware to properly locate the pads in the caliper bracket during a rear brake service.
Worn or corroded hardware can let pads bind, rattle, or wear unevenly. Fresh hardware helps the pads move as intended and quiets clips that have taken a set. Replacing this hardware alongside new rear pads is good practice for consistent, balanced braking. Consult the vehicle service information for correct fastener torque and whether any fasteners may be reused.
What vehicles does the 340-80035 fit?
It is a direct-fit rear brake hardware kit for the 2016-2018 Mazda CX-3 and the 2013-2015 Mazda CX-5. See the Buyer's Guide tab for engine-level details.
Is this for the front or rear brakes?
This kit is cataloged for the REAR disc brakes on the listed applications.
Should I replace the hardware when I do a brake job?
Yes, installing fresh hardware with new pads is recommended so the pads seat and slide correctly, which supports even, balanced braking.
Can worn hardware cause brake noise?
Worn or corroded clips and springs can let pads rattle, bind, or wear unevenly. If failed hardware is the cause, replacing it addresses that condition.
Does this kit include brake pads?
No. This is a hardware kit that supplies the clips, springs, and related hardware only; brake pads are sold separately.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
