Keep your rear brakes seating, sliding, and quieting the way the factory intended with the Dynamic Friction Company Disc Brake Hardware Kit (P/N 340-80046, also written 34080046). This rear disc brake hardware kit is a direct-fit replacement for the 2016-2025 Mazda CX-5, refreshing the small clips, springs, and abutment pieces that position the pads and manage their movement in the caliper bracket. Replacing worn hardware alongside new pads helps restore proper pad seating and consistent, rattle-free operation.
Fresh hardware is inexpensive insurance against uneven pad wear, noise, and dragging, so it's best installed whenever the rear pads are serviced on the listed application.
What is a disc brake hardware kit?
It's the set of small clips, springs, and abutment pieces that position the brake pads and let them slide freely in the caliper bracket for smooth, even, rattle-free braking.
Which vehicle does this kit fit?
It is a direct-fit replacement for the rear brakes of the 2016-2025 Mazda CX-5. See the Buyer's Guide tab to confirm the fit for your vehicle.
Is this for the front or rear brakes?
This kit is cataloged for the REAR disc brakes on the listed application.
Should I replace the hardware when I change my brake pads?
Yes, it's best practice to install fresh hardware with new pads. Worn clips and springs can cause uneven pad wear, noise, and dragging.
What are the manufacturer part numbers for this kit?
The manufacturer part number is 340-80046, also written 34080046.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
