Keep your front brakes seated, quiet, and moving freely with the Dynamic Friction Company Disc Brake Hardware Kit (MPN 340-93000, also written 34093000). This front disc brake hardware kit supplies the clips, springs, and abutment hardware that locate the pads and let them slide smoothly during braking, and it drops in as a direct-fit replacement for a wide range of GM trucks, vans, and SUVs.
Corrosion resistance: built to resist rust so the hardware keeps working in wet and salted conditions.
High heat resistance: holds up to the temperatures generated under repeated braking.
Low coefficient of friction: helps the pads slide freely against the hardware for even movement.
Easy assembly & removal: designed for straightforward installation and service, and it also resists chemical exposure.
Fresh hardware is recommended whenever you install new pads, since worn or corroded clips can cause noise, uneven pad wear, or sticking. Fits front applications including the 2003-2020 Chevrolet Express 2500, 2000-2005 Cadillac DeVille, 2001-2010 Chevrolet Silverado 2500 HD, 2003-2020 GMC Savana 3500, and 2003-2009 Hummer H2. See the Buyer's Guide tab for the full list of covered vehicles and years.
What is included in this hardware kit?
It supplies the front disc brake hardware — the clips, springs, and abutment pieces that locate the brake pads and allow them to slide during braking. Refer to the manufacturer listing for the exact contents.
Does this fit the front or rear brakes?
This is a front disc brake hardware kit. It is intended for the front brakes on the listed applications.
Should I replace the hardware when I install new pads?
Yes, it is recommended. Fresh clips and springs help prevent noise, uneven pad wear, and sticking, so installing new hardware with new pads is good practice.
Will this fit my vehicle?
It fits a wide range of GM applications such as the Chevrolet Express, Silverado 2500 HD, GMC Savana, and Hummer H2. Check the Buyer's Guide tab to confirm your year, make, and model.
Can worn brake hardware cause noise?
Yes. Corroded or worn clips and springs can let pads sit or slide incorrectly, which may cause noise, uneven pad wear, or sticking. Replacing the hardware helps address this if it is the cause.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
