Refresh the front brakes on your 2015-2020 Honda Fit with the Dynamic Friction Company Disc Brake Kit 4512-59141 — a complete front-axle package that pairs DFC GEOSPEC coated rotors with DFC 5000 ADVANCED ceramic pads and the matching hardware kit, so you get the rotors, pads, and clips in one box. It installs on the listed application with no modifications required.
GEOSPEC Coated Rotors: cast from the G3000/G11H18 iron specification and finished with the special silver-gray GEOSPEC coating for corrosion protection that DFC rates above conventional paint or zinc coatings. A non-directional finish is designed to promote a faster, more even pad bed-in and smoother stops, and vented rotors are 100% mill-balanced.
DFC 5000 ADVANCED Ceramic Pads: 100% asbestos-free and post-cured, then scorched to reduce initial break-in, with Premium Rubber-Steel-Rubber shims for improved NVH. Ceramic friction runs low-dust and quiet with a consistent pedal feel during everyday street driving.
Hardware Kit: built with stainless steel, PTFE coating, and vulcanized rubber, including rubber-coated abutment clips, chamfered and slotted where applicable to help reduce braking noise.
Direct-fit front kit for the 2015-2020 Honda Fit. See the Buyer's Guide tab for engine-level details.
What vehicles does this kit fit?
It is a direct-fit front-axle kit for the 2015-2020 Honda Fit. Check the Buyer's Guide tab to confirm the correct fit for your specific vehicle.
What comes in the kit?
You get DFC GEOSPEC coated front rotors, DFC 5000 ADVANCED ceramic front brake pads, and the matching disc brake hardware kit with clips — everything for a front brake job in one package.
What is the GEOSPEC coating?
It is a special silver-gray paint finish that DFC rates for corrosion protection above conventional paint or zinc coatings. Rotors ship dry and ready to install with no pre-degreasing needed.
Are the pads ceramic and how do they behave?
Yes, the DFC 5000 pads are ceramic and 100% asbestos-free. With Rubber-Steel-Rubber shims, they run low-dust and quiet with a consistent pedal feel during everyday street driving.
What are the rotors made of?
They are cast to the G3000/G11H18 iron specification, machined to tight tolerances with a non-directional finish, and vented rotors are 100% mill-balanced for smoother stops.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
