Dynamic Friction Company Disc Brake Kit P/N:4512-75048

Be the first to review this product
$151.99
MPN: 4512-75048
Item Package Quantity: 1
Adding to cart… The item has been added

Have questions?

Dynamic Friction Company Disc Brake Kit P/N:4512-75048
Dynamic Friction Company Disc Brake Kit P/N:4512-75048
$151.99

Do your rear brakes in a single box with the Dynamic Friction Company Disc Brake Kit 4512-75048, a direct-fit rear disc brake package for the 2006-2013 Lexus IS250 (see the Buyer's Guide tab for engine details). It bundles GEOSPEC coated rotors, DFC 5000 ceramic pads, and the matching hardware kit so the rear axle goes back together the first time.

  • GEOSPEC Coated Rotors: a silver-gray coating helps fight rust better than conventional paint or zinc finishes. Cast from G3000/G11H18 iron and given a non-directional finish to promote faster pad bed-in and smoother stops.
  • Ready to install: each rotor is processed dry and shipped dry, so no pre-degreasing is needed before it goes on.
  • DFC 5000 Ceramic Pads: 100% post-cured and scorched to reduce initial break-in, then built with Rubber-Steel-Rubber shims for improved noise, vibration, and harshness. Designed for low dust and quiet, consistent pedal feel during everyday street driving.
  • Hardware Kit: stainless steel with PTFE coating and rubber-coated abutment clips, chamfered and slotted where applicable to help reduce brake noise.

Every rotor carries a 12-month warranty against defects in material and workmanship.

Frequently Asked Questions

What's included in this kit?

It's a complete rear disc brake kit: DFC GEOSPEC coated rotors, DFC 5000 ceramic brake pads, and the matching disc brake hardware kit for the rear axle.

Does this kit fit my vehicle?

It's cataloged as a direct-fit rear kit for the 2006-2013 Lexus IS250. Check the Buyer's Guide tab to confirm the engine and application for your specific vehicle.

Are the brake pads ceramic?

Yes. The DFC 5000 pads use an asbestos-free ceramic formulation designed for low dust and quiet, consistent pedal feel during everyday street driving.

Do I need to clean the rotors before installing?

No. The GEOSPEC coated rotors are processed dry and shipped dry, so they install without any additional pre-degreasing preparation.

Should I replace both sides at once?

Replacing both rear sides together as a matched set is recommended for even, balanced braking. This listing covers the rear-axle kit.