Dynamic Friction Company Disc Brake Kit P/N:4512-76127
$197.99
(You save)
Refresh your front brakes in a single box with the Dynamic Friction Company Disc Brake Kit 4512-76127 — a complete DYNAMIC FRICTION brake kit that pairs DFC GEOSPEC coated rotors with DFC 5000 ceramic pads and the matching hardware. It installs as a front-axle kit for the 2005-2007 Toyota Avalon, 2005-2006 Toyota Camry, 2004-2010 Toyota Sienna and 2004-2008 Toyota Solara. See the Buyer's Guide tab to confirm the engine for your vehicle.
GEOSPEC coated rotors: a special silver-gray paint finish that resists rust better than conventional paint or zinc coatings. Each rotor is processed dry and shipped dry, ready to install with no pre-degreasing.
DFC 5000 ceramic pads: asbestos-free, 100% post-cured and scorched to minimize the initial break-in, with Rubber-Steel-Rubber shims for improved noise, vibration and harshness during everyday street driving.
Premium castings: G3000/G11H18 iron with a non-directional finish for faster bed-in and smoother stops; vented rotors are mill-balanced.
Hardware kit: stainless steel with PTFE coating, vulcanized rubber and rubber-coated abutment clips; chamfered and slotted where applicable to reduce noise.
Designed to meet the same form, fit and function as OEM brake components, so it drops in with no modifications required.
Frequently Asked Questions
Which vehicles does the 4512-76127 kit fit?
It's a front-axle kit for the 2005-2007 Toyota Avalon, 2005-2006 Toyota Camry, 2004-2010 Toyota Sienna and 2004-2008 Toyota Solara. Check the Buyer's Guide tab to confirm your engine.
What's included in this Toyota Avalon brake kit?
Front GEOSPEC coated rotors, DFC 5000 ceramic pads and a stainless steel hardware kit — the components to service one axle in a single package.
Are the brake pads ceramic?
Yes, DFC 5000 ceramic pads. They are asbestos-free, post-cured and scorched, with Rubber-Steel-Rubber shims to reduce noise, vibration and harshness during everyday driving.
Do the rotors need cleaning before installation?
No. Each GEOSPEC coated rotor is processed dry and shipped dry, ready to install with no pre-degreasing. The coating is safely swept away by the pads during bed-in.
Should I replace both sides at once?
Rotors and pads are best replaced as a matched set across the axle for even, balanced braking. This front kit covers one axle.
Write a Review
DYNAMIC FRICTION
Dynamic Friction Company Disc Brake Kit P/N:4512-76127
DFC GEOSPEC Coated Rotor - BlankCNC-Machined To The Tightest TolerancesOriginal Equipment (OE) Vane Configuration To Ensure Proper And Maximum Heat Dissipation100% Precision Cut And Mill-Balanced For...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
