Keep rear braking smooth and true with the DYNAMIC FRICTION brake rotor 604-63123, a direct-fit rear replacement for the 1998-2003 Mercedes-Benz ML320, the 2003-2005 Mercedes-Benz ML350, and the 1999 Mercedes-Benz ML430. This DFC GEOSPEC coated rotor is a blank (non-drilled, non-slotted) rear disc built to meet the same form, fit, and function as the OEM rotor it replaces.
Each rotor is CNC-machined to tight tolerances and quality tested. It arrives ready to install with no additional pre-degreasing needed, saving time during the job. Sold individually; for even, balanced braking it is best to replace the rotors on the rear axle as a matched pair. See the Buyer's Guide tab to confirm the exact application for your vehicle.
Does this DYNAMIC FRICTION brake rotor fit my Mercedes-Benz?
It is a direct-fit rear replacement for the 1998-2003 Mercedes-Benz ML320, 2003-2005 Mercedes-Benz ML350, and 1999 Mercedes-Benz ML430. Check the Buyer's Guide tab to confirm your exact vehicle.
Is this a front or rear rotor?
It is cataloged as a rear rotor for the listed Mercedes-Benz applications.
What does this disc brake rotor do?
It is the machined surface the brake pads clamp against to slow the wheel. A warped, scored, or worn rotor can cause vibration, noise, or reduced braking, which may be signs it needs replacing.
Is this rotor drilled or slotted?
No. It is a blank rotor with a non-directional finish and no drilled holes or slots.
Do I need to replace both rear rotors at once?
Rotors are sold individually, so this listing is for one. For even, balanced braking it is best to replace both rotors on the same axle as a matched pair.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
