Bring your Mazda 3 rotors back to a smooth, quiet stop with the Dynamic Friction GEOSPEC Coated Brake Rotor (P/N 604-80048, also written 60480048). This front rotor is a blank (smooth-faced) casting designed to match the form, fit, and function of the OEM rotor, dropping in as a direct-fit replacement for the 2007-2013 Mazda 3.
Key features:
It arrives ready to install with no additional pre-degreasing prep needed, saving time on the job. As a front-axle rotor, this DYNAMIC FRICTION brake rotor is sold individually; for even, balanced braking, replace the rotors on both sides of the axle as a matched pair and inspect your pads at the same time. Refer to the Buyer's Guide tab to confirm the correct front application for your Mazda 3.
Does this rotor fit my Mazda 3?
It is a front-axle rotor for the 2007-2013 Mazda 3. Confirm the correct front application for your vehicle in the Buyer's Guide tab before ordering.
Is this a front or rear disc brake rotor?
This is a front rotor. The catalog lists it for the front axle of the 2007-2013 Mazda 3.
What does the GEOSPEC coating do?
The GEOSPEC coating provides corrosion protection greater than zinc or conventional painting, helping guard the rotor against rust.
Should I replace the Mazda 3 brake pads and rotors together?
Inspect your pads whenever you replace rotors and renew them if worn. For even braking, replace the rotors on both sides of the axle as a matched pair.
Does this work for 2010 Mazda 3 brake rotors?
Yes — it fits the 2007-2013 Mazda 3, including 2010. It arrives ready to install with no pre-degreasing needed; verify the front fit in the Buyer's Guide tab.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
