Beck/Arnley 180-0703 crankshaft position sensor for the 1995-1997 Toyota Corolla 4-cylinder 1.6L or 1.8L and other vehicles reads crankshaft position and sends it to the engine computer. The computer uses that signal for ignition and fuel injection timing.
- Corrosion resistant terminals and coatings
- Designed for underhood conditions
- Application-specific design
Quick facts
- Part: Beck/Arnley 180-0703 crankshaft position sensor
- Also called: crank sensor
- Fits: 1995-1997 Toyota Corolla 4-cylinder 1.6L or 1.8L and other vehicles
- Condition: New
Hard starting, stalling or a rough-running engine can mean this sensor is worn, though a damaged wiring connector or a failing camshaft position sensor can be behind the same signs. The 1995-1997 Toyota Corolla 4-cylinder 1.6L or 1.8L takes one sensor, and this listing is a single sensor.
Fits
This sensor is a direct replacement for the 1995-1997 Toyota Corolla 4-cylinder 1.6L or 1.8L and the 1996-1997 Toyota Celica 4-cylinder 1.8L. Its form, fit and function match OE, including the strength of the magnet.
Specifications
- Quantity per vehicle: 1
- Terminals and coatings: corrosion resistant
- Condition: New
Interchange: 2132561 · 5S1897 · CSS545 · SS10196 · 80251057001 · 9091905011 · PC83 · SU4180
This part cross-references / interchanges with the following part numbers:
2132561, 5S1897, CSS545, SS10196, 80251057001, 9091905011, PC83, SU4180
Frequently Asked Questions
Is this the crank sensor for the 1995-1997 Toyota Corolla 4-cylinder 1.6L or 1.8L?
Yes. Beck/Arnley 180-0703 is listed for the 1995-1997 Toyota Corolla 4-cylinder 1.6L or 1.8L, and that car takes one sensor.
Are the terminals on 180-0703 protected against corrosion?
Yes. Beck/Arnley 180-0703 has corrosion resistant terminals and coatings, and the sensor is designed for underhood conditions.
Can a bad crankshaft position sensor cause stalling or a no-start?
Yes, it can. The engine computer relies on the crankshaft signal, so a failing sensor can show up as stalling, hard starting or a rough-running engine.
Is SU4180 the same as this sensor?
Yes, SU4180 is one of the numbers this sensor replaces, and the rest of the cross-reference numbers are on the Interchange line.
Does the Beck/Arnley crankshaft position sensor match the original magnet strength?
Yes. Its magnet strength matches OE, along with form, fit and function.
