FEL-PRO Fuel Injection Throttle Body Mounting Gasket P/N:61547
$8.99
(You save)
Seal the joint where the throttle body meets the intake and keep the incoming air properly metered with the FEL-PRO Fuel Injection Throttle Body Mounting Gasket 61547. It drops in as a direct-fit replacement for the 2002-2004 Acura RSX and 2002-2005 Honda Civic, renewing the sealing surface between the throttle body and the intake manifold.
A throttle body mounting gasket seals the connection so that only metered air passes downstream to the engine. When the original hardens, cracks, or is disturbed during a throttle-body cleaning or service, unmetered air can slip past the joint and upset the air-fuel ratio.
Direct-fit replacement: a clean-fitting replacement gasket for the listed applications.
Sealing job: restores the seal at the throttle body mounting surface, helping keep unmetered air out of the intake.
Signs it may need replacing: a rough or fluctuating idle, a hissing vacuum leak, or a lean condition after a throttle-body service. Diagnose the cause before replacing.
This part cross-references / interchanges with the following part numbers:
35533, 16176PRBA01, G32365, 711512000
Frequently Asked Questions
What does this gasket do?
It seals the joint where the throttle body mounts to the intake manifold so only metered air passes downstream, helping maintain the correct air-fuel ratio.
What vehicles does it fit?
It's a direct-fit replacement for the 2002-2004 Acura RSX and 2002-2005 Honda Civic. Check the Buyer's Guide tab to confirm your vehicle.
What are signs this gasket may need replacing?
A rough or high idle, a hissing vacuum leak, or a lean condition—often after a throttle-body cleaning. Diagnose the cause before replacing.
What numbers does it interchange with?
It cross-references 35533, 16176PRBA01, G32365, and 711512000.
Should I replace it when servicing the throttle body?
Many technicians fit a fresh mounting gasket whenever the throttle body is removed, since disturbing the old seal can allow unmetered air past the joint.
Write a Review
FEL-PRO
FEL-PRO Fuel Injection Throttle Body Mounting Gasket P/N:61547
Fel-Pro® gaskets are specifically designed for the repair environment to deliver a reliable seal on even the most troublesome applications. Designed for imperfect sealing surfaces and manufactured...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
