Four Seasons A/C Condenser Fan Motor Relay,HVAC Blower Motor Relay P/N:36129
Send power to your A/C condenser fan and HVAC blower motor with the Four Seasons relay 36188, a standard relay that lets a low-current control signal switch the higher current these motors draw. It fits many vehicles, among them the 2008-2010 Hyundai Elantra, 2006-2008 Hyundai Accent and 2010-2012 Hyundai Genesis Coupe, and serves as a direct-fit replacement for the listed applications.
A relay works as an electrically controlled switch. When the climate control system or engine management calls for the condenser fan or blower, the relay closes its contacts and completes the motor circuit. This keeps heavy current away from the dash switch and control modules. If a failed relay is behind a condenser fan or blower that won't run, this unit replaces it.
Signs this part may need replacing include a condenser fan or blower motor that doesn't run, runs only intermittently, or won't shut off. Blown fuses, wiring faults and worn motors can cause the same symptoms, so diagnose the circuit before you replace the relay. See the Buyer's Guide tab for the full list of vehicles.
Interchange: 1000735140 · 2303A200 · 952303A200 · 952303A400 · 1749010000 · A08940 · 20151
This part cross-references / interchanges with the following part numbers:
What does relay 36188 do?
It uses a low-current control signal to switch power to the A/C condenser fan motor and HVAC blower motor circuits. This lets a switch or module run those higher-current motors.
Which vehicles does this relay fit?
It fits many vehicles, including the 2008-2010 Hyundai Elantra, 2006-2008 Hyundai Accent and 2010-2012 Hyundai Genesis Coupe. See the Buyer's Guide tab for the full list.
Can I use this as a 2008-2010 Hyundai Elantra starter relay?
This relay is listed for the A/C condenser fan motor and HVAC blower motor circuits. Check your vehicle's service information for the relay specified in the starter circuit before you substitute it.
What are signs the relay may need replacing?
A condenser fan or blower that won't run, runs intermittently, or stays on can be signs of a failed relay. Fuses, wiring and motors can cause the same symptoms, so diagnose the circuit first.
How is this relay installed?
Its OE style molded connectors plug into the socket where the original relay sits. Follow your vehicle's service procedure, including any battery disconnect steps it calls for.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.