Bring new seals, boots and bleeder hardware back to your rear brakes with the Raybestos R-Line FRC11268, a remanufactured semi-loaded brake caliper for the rear left position that is 100% pressure tested. It fits many vehicles, among them the 2001-2010 Ford Explorer, 2003-2006 Jeep Wrangler and 2003-2007 Jeep Liberty, as a direct-fit replacement for the listed applications. See the "Vehicles it fits" section for the full list.
Raybestos R-Line non-plated calipers are remanufactured OE parts. Each casting, guide pin and bracket is carefully inspected before it is reused, and all rubber and sealing components are replaced with new ones. Every caliper is then rigorously tested. A disc brake caliper uses hydraulic pressure to push its piston and clamp the pads against the rotor. On this floating design, the caliper slides on its guide pins so that both pads meet the rotor.
- New replacement parts: seals, boots, bleeder screws, abutment hardware, banjo bolts and O-rings are replaced with new materials, intended for leak-free operation.
- EPDM70 rubber components: used for heat resistance, performance and durability.
- OE-matched materials: the materials match OE specifications and meet vehicle-specific designs.
- Pressure tested: every caliper is 100% pressure tested.
Specifications: floating caliper with a cast iron casting, a 1.886 in (47.9 mm) piston diameter and a 3/8-24 bleeder screw thread. It mounts in the rear left position, one per application. Country of origin: Mexico.
Product information is for general reference and may contain errors. See our Disclaimer.
Frequently Asked Questions
What does this rear left brake caliper do?
It turns hydraulic pressure from the brake pedal into clamping force. It pushes its 1.886 in (47.9 mm) piston so the pads squeeze the rotor, and as a floating caliper it slides on guide pins to apply both pads.
Will this Jeep Wrangler brake caliper fit my 2003-2006 Wrangler?
Yes. FRC11268 is listed for the rear left position on the 2003-2006 Jeep Wrangler with all engines, one per application. The "Vehicles it fits" section shows every listed vehicle.
Is this a rear caliper for the 2001-2010 Ford Explorer?
Yes. It is listed for the rear left position on the 2001-2010 Ford Explorer with all engines. It is also listed for the 2003-2007 Jeep Liberty.
What parts are replaced new during remanufacturing?
Seals, boots, bleeder screws, abutment hardware, banjo bolts and O-rings are replaced with new materials. Castings, guide pins and brackets are inspected before reuse, and every caliper is pressure tested.
What are signs a brake caliper may need replacing?
Common signs are fluid leaking at the caliper, pulling to one side, a dragging brake or burning smell, and uneven pad wear. Diagnose the cause first, because other brake parts can cause similar symptoms.
