Raybestos Brakes Disc Brake Caliper P/N:FRC12013N
Raybestos Brakes FRC11360 rear right brake caliper for the 2003-2006 Chevrolet Silverado 1500 and other vehicles squeezes the pads against the rotor to slow the wheel. This remanufactured semi-loaded disc brake caliper comes with its bracket.
Fluid around the wheel, uneven pad wear or a pull to one side can mean the caliper is worn, though the brake hose or the pads can be behind the same signs, so find the cause before replacing it.
This rear right brake caliper and bracket assembly is a direct-fit replacement for the 2003-2006 Chevrolet Silverado 1500, the 2003-2006 GMC Sierra 1500 and the 2006-2011 Cadillac DTS, with one caliper per vehicle at that wheel. Open the "Vehicles it fits" section to check your exact model and engine. This listing is one caliper; the rear left side is ordered separately, and both sides are normally replaced together.
Fit and size
Build and materials
One remanufactured semi-loaded brake caliper with its bracket.
Interchange: 15-14375 · 99-17378B · 18-B4855 · 18-P4855 · 19-B2746 · 141.66521 · 142.66521 · 11-4375
SC0198A
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this a 2006-2011 Cadillac DTS brake caliper for the rear right wheel?
Yes. Raybestos Brakes FRC11360 fits the 2006-2011 Cadillac DTS at the rear right, one per car at that wheel. The rear left side is a separate part.
Can I use this as a 2003-2006 Chevrolet Silverado 1500 brake caliper on the right rear?
Yes. This rear right caliper fits the 2003-2006 Chevrolet Silverado 1500. The left rear takes its own caliper, which is ordered separately.
Does the Raybestos Brakes FRC11360 caliper come with its bracket?
Yes. FRC11360 is a semi-loaded caliper and bracket assembly. It is remanufactured with new seals, boots, bleeder screws, abutment hardware, banjo bolts and O-rings.
What piston size and bleeder thread does this rear right caliper have?
The piston diameter is 54 mm (2.126 in) and the bleeder screw thread is M10x1. This is a floating caliper with an aluminum casting.
How is this remanufactured Raybestos R-Line caliper tested?
Each caliper is 100% pressure tested. Castings, guide pins and brackets are inspected before they are reused.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.