Keep hot coolant moving between the intake manifold and heater core with the Gates Molded Heater Hose 19116, a factory-molded, OEM-style hose that installs on the 1998-2001 Toyota Camry [L4-2.2L] and 1999-2001 Toyota Solara [L4-2.2L]. Its small-I.D. molded shape is built to route through today's smaller, tighter-fitting engine compartments, carrying coolant from the intake manifold to the heater.
Approved for coolant, water, air, and marine applications; do not use for fuel or oil transfer. Gates recommends replacing hose clamps each time a new coolant hose is installed. Made in the United States.
Interchange: 16265M · 87883 · F10046 · 11116 · 8724506101 · 8724533171
This part cross-references / interchanges with the following part numbers:
What does this heater hose do?
It carries engine coolant from the intake manifold to the heater, part of the cooling and cabin-heat circuit. It is molded to route through tight engine-compartment spaces.
Which vehicles does the Gates 19116 fit?
It is a direct-fit replacement for the 1998-2001 Toyota Camry [L4-2.2L] and the 1999-2001 Toyota Solara [L4-2.2L]. Confirm the fitment for your vehicle.
What is this hose made of?
It has an EPDM tube, synthetic fiber knit reinforcement, and an EPDM cover, engineered to resist electrochemical degradation — the leading cause of hose failure.
Can I use this hose for fuel or oil lines?
No. It is approved for coolant, water, air, and marine applications, but Gates cautions against using it for fuel or oil transfer applications.
Do I need new clamps when installing it?
Gates recommends replacing the hose clamps each time a new coolant hose is installed. Consult the vehicle service information for the correct clamps.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
