Keep coolant moving through the heater circuit with the Gates Molded Heater Hose (P/N 19360). This factory-molded, OEM-style hose is engineered to route between the TEE-2 and PIPE-2 connections and drops in as a direct-fit replacement for the 2005-2006 and 2008 Chrysler 300 (V8-5.7L), 2005-2008 Chrysler 300 (V8-6.1L), 2008 Dodge Charger (V8-5.7L), 2007-2008 Dodge Charger (V8-6.1L), 2005-2006 and 2008 Dodge Magnum (V8-5.7L), and 2006-2008 Dodge Magnum (V8-6.1L).
- Molded to fit: Factory-molded, OEM-style hose shaped for today's smaller, tighter-fitting engine compartments; similar to OEM specifications.
- Durable construction: EPDM tube, synthetic fiber knit reinforcement, and EPDM cover, engineered to resist electrochemical degradation — the leading cause of hose failure.
- Rated to spec: Meets SAE 20R3 Type EC Class D-1 and D-2 specifications, with a temperature range of -40°F to 275°F.
- Versatile use: Suitable for coolant, water, and air applications, and also approved for marine applications.
Centerline length measures 12.6 in (320 mm), with a .63 in (16 mm) inside diameter at one end and a .75 in (19 mm) inside diameter at the other. Caution: do not use for fuel or oil transfer applications. Gates recommends replacing hose clamps each time a new coolant hose is installed. Made in the United States.
Interchange: 14421S · 4596574AB · 4596574AC · B91164 · 64534 · 11360
This part cross-references / interchanges with the following part numbers:
Frequently Asked Questions
What vehicles does this Gates 19360 heater hose fit?
It fits the 2005-2006 and 2008 Chrysler 300 (V8-5.7L), 2005-2008 Chrysler 300 (V8-6.1L), 2008 Dodge Charger (V8-5.7L), 2007-2008 Dodge Charger (V8-6.1L), and 2005-2008 Dodge Magnum (V8-5.7L and V8-6.1L). See the Buyer's Guide tab.
What is this hose made of?
It has an EPDM tube, synthetic fiber knit reinforcement, and an EPDM cover, engineered to resist electrochemical degradation — the leading cause of hose failure.
What are its dimensions?
The centerline length is 12.6 in (320 mm). One end has a .63 in (16 mm) inside diameter and the other has a .75 in (19 mm) inside diameter.
Can this hose be used for fuel or oil?
No. Gates cautions against using it for fuel or oil transfer applications. It is intended for coolant, water, and air, and is also approved for marine applications.
Should I replace the hose clamps when installing this?
Gates recommends replacing the hose clamps each time a new coolant hose is installed.
Write a Review