Keep coolant flowing between the radiator and engine with the Gates Radiator Coolant Hose 22988. This molded upper coolant hose is a direct-fit replacement for the 2004-2007 Mitsubishi Lancer with the L4-2.0L engine, pre-shaped so it routes and seats without cutting or bending a universal length. Gates molds its coolant hoses to OEM-quality specifications for upper, lower, bypass, heater and other coolant applications, so you can skip the OE dealer for a radiator hose replacement.
- Pre-shaped fit: Preformed to route and seal correctly in the intended coolant application.
- Vacuum resistance: Specifically-engineered materials resist collapse under vacuum.
- Degradation resistance: Engineered to resist electrochemical degradation, the leading cause of hose failure.
- EPDM build: EPDM tube with synthetic fiber knit reinforcement and a heat-, ozone- and chemical-coolant-resistant EPDM cover.
Meets the requirements of SAE 20R4 class D2 and DIN 73411 class A (except for tolerances), with a temperature range of -40°F to +257°F (-40°C to +125°C). Do not use for fuel or oil transfer applications. Gates recommends replacing hose clamps each time a new coolant hose is installed. Country of origin: United States.
Interchange: 20437S · 62879 · B90740 · MN135916 · 9626 · Manufacturer part number 22988
This part cross-references / interchanges with the following part numbers:
Frequently Asked Questions
Does this hose fit my vehicle?
It is a direct-fit upper coolant hose for the 2004-2007 Mitsubishi Lancer with the L4-2.0L engine. Check the Buyer's Guide tab to confirm fitment for your vehicle.
What is the hose made of?
It has an EPDM tube, synthetic fiber knit reinforcement, and a heat-, ozone- and chemical-coolant-resistant EPDM cover.
What temperature range does it handle?
Its rated temperature range is -40°F to +257°F (-40°C to +125°C), and it meets SAE 20R4 class D2 and DIN 73411 class A requirements (except for tolerances).
Can I use this hose for fuel or oil?
No. This is a coolant hose only; do not use it for fuel or oil transfer applications.
Do I need new hose clamps?
Gates recommends replacing the hose clamps each time a new coolant hose is installed.
Write a Review