Keep coolant moving and joints leak-free with the Gates Premium Molded Coolant Hose 23040, a direct-fit replacement for the 2005-2010 Jeep Grand Cherokee [V6-3.7L] and 2006-2010 Jeep Commander [V6-3.7L]. It's pre-shaped to route into place and help ensure a properly sealed connection, so you can skip the OE dealer trip for a radiator hose replacement.
Gates recommends replacing the hose clamps each time a new coolant hose is installed. Do not use for fuel or oil transfer applications. Made in the United States.
Interchange: Manufacturer part number 23040.
This part cross-references / interchanges with the following part numbers:
What vehicles does the Gates 23040 fit?
It's a direct-fit replacement for the 2005-2010 Jeep Grand Cherokee [V6-3.7L] and 2006-2010 Jeep Commander [V6-3.7L]. Check the Buyer's Guide tab to confirm your vehicle.
What is this hose made of?
It has an EPDM tube, synthetic fiber knit reinforcement, and a heat-, ozone- and chemical coolant-resistant EPDM cover.
Will it hold its shape under engine conditions?
Its specifically-engineered materials resist collapse under vacuum, and it's engineered to resist electrochemical degradation, a leading cause of hose failure.
Should I replace the hose clamps too?
Yes. Gates recommends replacing the hose clamps each time a new coolant hose is installed.
Can I use this hose for fuel or oil lines?
No. This is a coolant hose only; do not use it for fuel or oil transfer applications. It's rated for -40°F to +257°F.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
