Keep coolant circulating and your engine at its proper operating temperature with the Gates Molded Radiator Coolant Hose 23473. This molded hose is cataloged in the lower radiator-to-tee, lower-front position and drops in as a direct-fit replacement for the 2007 Chevrolet Cobalt [L4-2.4L] and the 2008-2010 Chevrolet HHR [L4-2.0L].
Gates recommends replacing the hose clamps whenever a new coolant hose is installed. Do not use for fuel or oil transfer applications. Made in the United States.
Interchange: 22647M · 66114 · 73147 · D73147 · 15940317 · 16209
Manufacturer part number 23473.
This part cross-references / interchanges with the following part numbers:
Which vehicles does this hose fit?
It's a direct-fit replacement for the 2007 Chevrolet Cobalt [L4-2.4L] and the 2008-2010 Chevrolet HHR [L4-2.0L]. See the Buyer's Guide tab to confirm the fit for your vehicle.
Where is this hose located?
It is cataloged in the lower position, running from the radiator to the tee (lower front) on the listed applications.
What is the hose made of?
It uses an EPDM tube, synthetic fiber knit reinforcement, and an EPDM cover that resists heat, ozone and chemical coolants.
Do I need new hose clamps?
Gates recommends replacing the hose clamps each time a new coolant hose is installed. Consult the vehicle service information for the correct clamps.
Can I use this hose for fuel or oil?
No. This is a coolant hose only—do not use it for fuel or oil transfer applications.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
