Take command of precise electronic throttle control with the Hitachi Astemo Electronic Throttle Body ETB0104. This brand-new (not remanufactured) unit installs as a direct-fit replacement for the 2007-2009 Honda CR-V [L4-2.4L], electronically metering intake air into the engine for accurate, responsive throttle operation.
- Electric actuation: a drive-by-wire electronic throttle body that opens and closes the throttle plate on command from the engine control module.
- Integrated Throttle Position Sensor: the throttle position sensor is included, with precision TPS circuitry that reports throttle angle to keep engine mapping accurate.
- 6-terminal connector: six male blade terminals in a rectangular connector housing.
Hitachi builds its ETBs from high-quality materials intended to resist deformation and malfunction under demanding conditions, supporting normal engine performance, fuel economy, and emissions when a worn or failed throttle body is the cause. Note that an idle air control motor, gasket or seal, and mounting hardware are not included; consult the vehicle service information for the correct hardware and fasteners. Country of origin: Taiwan.
Interchange: 16400-RZA-J01 · 16400RZAJ01 · Manufacturer part number ETB0104
This part cross-references / interchanges with the following part numbers:
Frequently Asked Questions
What does this throttle body do?
It is an electronic (drive-by-wire) throttle body that opens and closes the throttle plate on command from the ECM, electronically metering intake air into the engine for accurate throttle response.
Which vehicle does the ETB0104 fit?
It is a direct-fit replacement for the 2007-2009 Honda CR-V with the L4-2.4L engine. Confirm your vehicle in the Buyer's Guide tab before ordering.
What are signs this throttle body may need replacing?
Signs can include a rough or erratic idle, hesitation, reduced throttle response, or a throttle/check-engine warning light. Diagnose the cause first; if a failed throttle body is confirmed, this replaces it.
Is a throttle position sensor included, and what is not?
Yes, the throttle position sensor is integrated. An idle air control motor, gasket or seal, and mounting hardware are not included.
What part number does this replace?
It carries interchange OE number 16400-RZA-J01 (also 16400RZAJ01). The manufacturer part number is ETB0104.
Write a Review