Standard Ignition ABS Wheel Speed Sensor P/N:ALS3168
Standard Motor Products
STANDARD MOTOR PRODUCTS ALS1658 front ABS wheel speed sensor for the 2008-2014 Nissan Rogue and other vehicles reports wheel speed to the ABS. The ABS control unit uses that signal to spot a wheel that slows faster than the others.
A failing wheel speed sensor can show up as an ABS warning light, and a damaged harness or a dirty connector can light it too. With the vehicle parked and the engine off, look at the wiring and connector you can see for cuts, rust or fluid before replacing the sensor. A shop can scan for codes to narrow down the cause.
This sensor is listed for a wide range of Nissan and Renault models, led by the 2008-2014 Nissan Rogue, the 2009-2016 Renault Koleos and the 2014-2015 Nissan Rogue Select. Open the "Vehicles it fits" section to check your exact model and engine. The 2008-2014 Nissan Rogue takes two front sensors, and this listing is one.
Fit and size
Build and materials
One front ABS wheel speed sensor with its harness. Mounting hardware is not included, so plan on a new mounting bolt.
Interchange: ABS1747 · SU12685 · 532117 · 532117SB · 479101DA1A · 47910JG000 · VSS193 · ALS1658T
This part cross-references / interchanges with the following part numbers:
Is the STANDARD MOTOR PRODUCTS ALS1658 sensor right for the 2008-2014 Nissan Rogue?
Yes. The STANDARD MOTOR PRODUCTS ALS1658 is a front ABS wheel speed sensor listed for the 2008-2014 Nissan Rogue, which takes two. Open the "Vehicles it fits" section to check other models.
Will this front ABS wheel speed sensor fit the 2009-2016 Renault Koleos?
Yes. The 2009-2016 Renault Koleos is listed for this sensor and takes one.
Does the ALS1658 come with the mounting bolt?
No. Mounting hardware is not included with the STANDARD MOTOR PRODUCTS ALS1658, so plan on a new bolt. The grommets and wire clips come on the sensor's harness.
How long is the harness on this ABS wheel speed sensor?
The harness is 30 inches (760 mm) long and ends in one rectangular male connector with two terminals.
Where does this ABS speed sensor mount, and how many bolts hold it?
This sensor is a bolt mount at the spindle, with one bolt hole.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.