Keep the rear of your Toyota or Lexus planted with the KYB Excel-G Suspension Strut 235043, a nitrogen gas-charged, twin-tube unit built to the rear-left position. It fits the 1987-1991 Toyota Camry and 1990-1991 Lexus ES250 — see the Buyer's Guide tab for engine-specific applications. KYB builds the Excel-G on the same assembly lines and with the same OE-quality components as its factory-supplied products, calibrated to help restore the vehicle's originally designed ride control, stability, and handling rather than change it.
Twin-tube gas design: nitrogen gas-charged for consistent damping.
Strong strut body: KYB uses thick strut bodies and brackets to minimize flex and help maintain correct alignment.
Triple-lip fluid seal: designed to reduce the chance of oil and gas leaking out.
Hand-assembled damping valves: vehicle-specific valving manages tire contact, steering response, and body movement.
KYB recommends installing new strut mounts (part number SM5375) to reduce the chance of noise and vibration, and protecting the new strut from dirt, debris, and salt with a KYB Strut Boot (part number SB105). Struts are best replaced in matched pairs across the axle for balanced ride and handling.
Interchange: G55589 · 71861
This part cross-references / interchanges with the following part numbers:
Frequently Asked Questions
What vehicles does the KYB 235043 strut fit?
It fits the 1987-1991 Toyota Camry and 1990-1991 Lexus ES250. Check the Buyer's Guide tab to confirm the engine-specific application for your vehicle.
What position is this strut for?
This is the rear-left strut. Confirm the corner for your vehicle before ordering.
What type of strut is the Excel-G?
It is a nitrogen gas-charged, twin-tube design classified as OEA (Original Equipment for the Aftermarket), built to help restore the vehicle's original ride control and handling.
Should I replace struts in pairs?
KYB struts are sold individually, but replacing both sides of the axle as a matched pair is recommended for balanced ride and handling.
Are strut mounts or a boot included?
No. KYB recommends installing new strut mounts (part number SM5375) and a KYB Strut Boot (part number SB105) separately to reduce noise and protect the new strut.
Write a Review