Restore original ride control and handling with the KYB Excel-G Suspension Strut 343191, a nitrogen gas-charged, twin-tube rear strut built to bring back your vehicle's designed capability. It's a direct-fit replacement for the 1995-2002 Volkswagen Cabrio, 1990-1992 Volkswagen Corrado, 1985-1998 Volkswagen Golf, and 1985-1999 Volkswagen Jetta — see the Buyer's Guide tab for engine-level fitment.
KYB is a leading supplier of shocks and struts to new-vehicle manufacturers, and the Excel-G is made on the same OE assembly lines using the same OE-quality components, calibrated to restore original performance rather than change it — earning its OEA (Original Equipment for the Aftermarket) classification.
- Nitrogen gas-charged twin-tube design: includes the same quality components found in KYB's global OEM products.
- Triple-lip fluid seal: helps reduce the chance of oil and gas leaking out.
- Vehicle-specific, hand-assembled damping valves: calibrated to manage tire contact, steering response, and body movement.
- Strong, thick strut bodies and brackets: minimize flex to help maintain correct alignment.
KYB recommends installing new strut mounts (part number SM5070) to reduce the chance of noise and vibration, and protecting your new struts from dirt, debris, and salt with a KYB Strut Boot (part number SB115).
Interchange: G51022 · 71265
This part cross-references / interchanges with the following part numbers:
Frequently Asked Questions
What vehicles does strut 343191 fit?
It's a rear-position replacement for the 1995-2002 VW Cabrio, 1990-1992 VW Corrado, 1985-1998 VW Golf, and 1985-1999 VW Jetta. Check the Buyer's Guide tab for engine-level fitment.
What type of strut is this?
The KYB Excel-G is a nitrogen gas-charged, twin-tube strut built on KYB's OE assembly lines with OE-quality components, calibrated to restore the vehicle's original designed performance.
What does the OEA classification mean?
OEA stands for Original Equipment for the Aftermarket. It reflects that the Excel-G uses the same OE-quality components and calibration as KYB's OEM products to restore original performance, not change it.
Should I replace struts in pairs?
Replacing both struts on the same axle together as a matched pair is recommended for balanced ride and handling. This listing is for one strut.
Are strut mounts or boots included?
No. KYB recommends installing new strut mounts (part number SM5070) and a KYB Strut Boot (part number SB115) with your new struts; consult the service procedure for the correct hardware.
Write a Review