Seal the intake manifold and keep metered air flowing cleanly with the MAHLE Engine Intake Manifold Gasket Set (MS19819). This set drops in as a direct-fit replacement for the listed BMW applications, providing the sealing components needed where the intake manifold mates to the engine.
- Restores the intake-to-engine seal: replaces worn or hardened gaskets so the manifold seats against the mating surface without air leaks.
- Preserves metered airflow: a tight seal helps keep unmetered air from entering downstream of the throttle, which can cause a lean condition or rough idle.
- Reseal-ready set: supplies the intake manifold gasket components for a manifold service on the covered engines.
Worn intake manifold gaskets often show up as a vacuum leak, rough or unstable idle, or a stored lean-condition code. If failed intake manifold gaskets are the cause, this set replaces them during the repair; diagnose the source of the leak before ordering.
Fits: 2002-2005 BMW 745I, 2002-2005 BMW 745LI, 2004-2005 BMW 545I, 2004-2005 BMW 645CI, 2004-2006 BMW X5, and 2007-2008 BMW ALPINA B7. See the Buyer's Guide tab to confirm your vehicle.
Interchange: 11 61 7 521 181 · 11617521181 · 037-6196 · 0376196 · MS97538 · Manufacturer part number MS19819
This part cross-references / interchanges with the following part numbers:
Frequently Asked Questions
What does this MAHLE intake manifold gasket set do?
It seals the joint where the intake manifold meets the engine, helping keep metered air flowing cleanly and preventing air leaks that can cause a lean condition or rough idle.
Which vehicles does the MS19819 set fit?
It's a direct-fit replacement for the 2002-2005 BMW 745I and 745LI, 2004-2005 BMW 545I and 645CI, 2004-2006 BMW X5, and 2007-2008 BMW ALPINA B7. Check the Buyer's Guide tab to confirm.
What are signs my intake manifold gaskets may need replacing?
Common signs include a vacuum leak, rough or unstable idle, and a stored lean-condition code. Diagnose the source before replacing, as other components can cause these symptoms.
What interchange numbers does this part replace?
It cross-references 11 61 7 521 181 (11617521181), 037-6196 (0376196), and MS97538. The manufacturer part number is MS19819.
Should I replace all the gaskets at once?
Yes. When servicing the intake manifold, it's best to install the full set so every mating surface is resealed together for a reliable seal.
Write a Review