Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS101580
$232.99
(You save)
Bring your BMW's front suspension back to spec with the Mevotech Supreme control arm and ball joint assembly (CMS101580). This forged-steel unit locates the front left lower rearward position, connecting the wheel hub to the chassis while the integrated ball joint allows steering and suspension travel and the pressed-in rubber bushings isolate road vibration. It drops in as a direct-fit replacement for the 2019-2024 BMW X5, 2019-2025 BMW X7, 2020-2024 BMW X6, and 2021-2024 BMW ALPINA XB7 — see the Buyer's Guide tab for the full engine-level list.
Forged steel construction: built to OE-level strength for high-usage passenger vehicles, SUVs, fleets and working trucks.
Faster fit: includes a part-specific nylon locking nut to speed ball joint installation.
Resists corrosion: a protective surface treatment helps prevent rust build-up.
Precise engineering: designed in-house with application-specific durability upgrades and validated by in-house and third-party testing.
If worn control-arm bushings or a loose ball joint are behind clunking over bumps, imprecise steering, or uneven tire wear, this Mevotech Supreme suspension control arm replaces the failed original in one assembly.
What vehicles does the Mevotech Supreme CMS101580 fit?
It's a direct-fit replacement for the 2019-2024 BMW X5, 2019-2025 BMW X7, 2020-2024 BMW X6, and 2021-2024 BMW ALPINA XB7. Check the Buyer's Guide tab to confirm the engine-level fit for your vehicle.
Where is this BMW X5 control arm located?
This unit is cataloged for the front left (driver's side) lower rearward position. Confirm the fitment for your specific vehicle before ordering.
Does this Mevotech Supreme lower control arm include the ball joint?
Yes. It ships as one pre-assembled unit with the ball joint already installed, plus a part-specific nylon locking nut to speed the ball joint installation.
What is the CMS101580 control arm made of?
It features forged steel construction built to OE-level strength, plus a protective surface treatment that helps resist corrosion.
Should I replace the control arm on both sides?
This listing is for one assembly (front left lower rearward). Inspect the corresponding side; replacing worn suspension parts in pairs helps keep handling balanced.
Write a Review
Mevotech Supreme
Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS101580
Keep the front suspension tight and precise with the Mevotech Supreme control arm and ball joint assembly (P/N: CMS86142), a front right lower unit that drops in as a direct-fit replacement for the...
Steer with tight, predictable response using the Mevotech Supreme control arm and ball joint assembly (CMS40121), a front right upper unit that locates the suspension and carries an integrated ball...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
