Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS20365
$86.99
(You save)
Keep your steering tight and your ride controlled with the Mevotech Supreme control arm and ball joint assembly (CMS20365), a front left (driver-side) lower unit that locates the wheel and lets the suspension travel. It installs as a direct-fit replacement for the 2001-2010 Chrysler PT Cruiser and the 2003-2005 Dodge Neon — see the Buyer's Guide tab to confirm your exact engine.
Stamped steel construction: built to OE-level tolerances for the demands of high-usage passenger vehicles, SUVs, fleets and working trucks.
Integrated ball joint: the pressed-in ball joint with its rubber dust boot comes assembled to the arm, so you replace the arm and joint in one step.
Resists corrosion: a protective surface treatment helps guard against rust build-up.
Rigorously tested: extensive in-house and third-party durability testing backs its strength.
This Mevotech Supreme suspension control arm carries application-specific upgrades and Labor Saver™ hardware to speed installation. Worn arm bushings or a loose ball joint can show up as clunking, uneven tire wear, or wandering steering; if a failed front lower control arm or ball joint is the cause on your PT Cruiser or Neon, this assembly replaces it. Sold individually — order two if you are replacing both sides for balanced handling.
Frequently Asked Questions
What vehicles does the CMS20365 control arm fit?
It is a front left lower control arm and ball joint assembly for the 2001-2010 Chrysler PT Cruiser and the 2003-2005 Dodge Neon. Check the Buyer's Guide tab to confirm your exact engine.
Which position is this Pt Cruiser control arm?
This is the front left (driver-side) lower control arm. If you also need the passenger side, order a second matching unit; each is sold individually.
Does this lower control arm for Pt Cruiser include the ball joint?
Yes. The ball joint is pressed into the arm and comes pre-assembled with its rubber dust boot, so the arm and joint install together as one assembly.
What is this Neon control arm made of?
It uses stamped steel construction built to OE-level tolerances, and a protective surface treatment helps resist rust build-up.
What are the signs I need this control arm?
Clunking over bumps, uneven tire wear, or loose, wandering steering can signal worn bushings or a failed ball joint. Have the cause diagnosed, since these symptoms can have other sources.
Write a Review
Mevotech Supreme
Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS20365
Keep the front suspension tight and precise with the Mevotech Supreme control arm and ball joint assembly (P/N: CMS86142), a front right lower unit that drops in as a direct-fit replacement for the...
Steer with tight, predictable response using the Mevotech Supreme control arm and ball joint assembly (CMS40121), a front right upper unit that locates the suspension and carries an integrated ball...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
