Keep your Mazda's front end tracking true with the Mevotech Supreme control arm, part number CMS20448. This front right lower control arm and ball joint assembly drops in as a direct-fit replacement for the 1998-2002 Mazda 626, locating the wheel through its range of motion while the integrated ball joint carries the steering knuckle and allows it to pivot as you steer and the suspension travels.
A worn lower control arm or ball joint can show up as clunking over bumps, a wandering or loose steering feel, and uneven front tire wear. If a failed arm or ball joint is the cause, this Mevotech Supreme lower control arm replaces both in one pre-assembled unit. Have an alignment performed after installation.
What vehicles does the Mevotech Supreme suspension control arm CMS20448 fit?
It is a direct-fit replacement for the 1998-2002 Mazda 626. Check the Buyer's Guide tab to confirm it matches your specific vehicle and engine.
Is this a front or rear control arm, and which side?
CMS20448 is cataloged as the front right lower control arm and ball joint assembly.
Does this Mazda 626 control arm include the ball joint?
Yes. The ball joint is integrated into this pre-assembled unit, so you replace the arm and ball joint together in one part.
What are the signs this control arm or ball joint may need replacing?
Common signs include clunking over bumps, a loose or wandering steering feel, and uneven front tire wear. Have the cause diagnosed before replacing.
What is this control arm made of?
It uses stamped steel construction with a protective surface treatment that helps resist corrosion.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
