Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS301170
$229.99
(You save)
Keep your front suspension tight and quiet with the Mevotech Supreme Suspension Control Arm and Ball Joint Assembly (CMS301170). This front right lower control arm arrives with its ball joint and bushings pre-assembled, dropping in as a direct-fit replacement for the 2013-2018 Nissan Altima and 2016-2023 Nissan Maxima. It locates the wheel, connects the knuckle to the chassis, and lets the ball joint pivot for steering and suspension travel — worn bushings, a loose ball joint, clunking on bumps or uneven tire wear are signs this assembly may need replacing.
Forged aluminum arm: A forged aluminium control arm with a filled-in hole/recess and structure change adds durability and strength.
Patented BiMetallic bearing: Greaseable sintered bearing technology is engineered to address high heat and high load in tight spaces for extended service life.
Longer ball joint life: Additional surface treatment helps prevent rust build-up on the ball joint.
Stiffer, serviceable build: Bushings with a solid cross section increase stiffness, and a 90-degree SAE grease fitting plus an application-specific pinch bolt and locking nut are included.
It's a direct-fit front right lower assembly for the 2013-2018 Nissan Altima and 2016-2023 Nissan Maxima. Check the Buyer's Guide tab to confirm your exact application.
Which position is this control arm?
This is the front right lower control arm and ball joint assembly. Order the corresponding side if you need to replace both.
Does it come with the ball joint and hardware?
Yes. The ball joint and bushings are pre-assembled, and an application-specific pinch bolt and locking nut plus a 90-degree SAE grease fitting are included.
What are the signs I need to replace this control arm?
Clunking over bumps, loose or sloppy steering, uneven tire wear, or a worn ball joint or bushings can indicate this assembly needs replacing. Diagnose the cause before replacing.
Can the ball joint be greased?
Yes. It uses Mevotech's greaseable BiMetallic sintered bearing and includes a 90-degree SAE grease fitting for simple servicing.
Write a Review
MEVOTECH
Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS301170
Suspension Control Arm and Ball Joint AssemblyMevotech Supreme Parts™ are engineered in-house, with application-specific upgrades for increased durability and performance. Mevotech Supreme control...
Keep your front suspension tight and precise with the Mevotech Supreme Suspension Control Arm and Ball Joint Assembly CMK80038 — a front, right (passenger-side) upper unit engineered in-house with...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
