Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS401262
$161.99
(You save)
Keep the wheel properly located and steering response tight with the Mevotech Supreme Suspension Control Arm and Ball Joint Assembly (CMS401262). It installs as a direct-fit replacement for the 2015-2019 Lincoln MKC [All], arriving as a complete corner solution with the ball joint and rubber bushing already pressed and pre-assembled so you can bolt it in and go.
Faster installation: the additional ball joint and bushing come pre-assembled for a complete, ready-to-fit unit.
Superior toughness: sintered-metal bearings are built for longer-lasting performance under high use.
Simple to service: ships pre-greased and greaseable with a 180-degree SAE grease fitting included.
Larger sphere design: an application-specific ball stud system with a larger sphere and grooved stud.
Fasteners included: an application-specific pinch bolt and locking nut are provided to speed ball-joint install.
Built with stamped steel construction (black finish) to meet or exceed OE specifications, the press-in ball joint is protected by a blue neoprene dust boot, while the rubber bushing helps isolate vibration. This is a non-adjustable assembly. Signs the original may need replacing include clunking or knocking from the suspension over bumps, loose or wandering steering, and uneven tire wear; if a worn control arm or ball joint is the cause, this assembly replaces it. Sold individually. Country of origin: China. Manufacturer part number CMS401262.
This part cross-references / interchanges with the following part numbers:
It arrives complete: the control arm with a pre-assembled press-in ball joint, rubber bushing, blue neoprene dust boot, an SAE grease fitting, plus the pinch bolt and locking nut mounting hardware.
What vehicle does CMS401262 fit?
It is a direct-fit replacement for the 2015-2019 Lincoln MKC [All]. Check the Buyer's Guide tab to confirm the fit for your vehicle.
Is the ball joint greaseable?
Yes. The assembly ships pre-greased and is greaseable, with a 180-degree SAE grease fitting included for simple servicing.
What is the control arm made of?
It uses stamped steel construction with a black finish, built to meet or exceed OE specifications, and runs on sintered-metal bearings with a neoprene dust boot.
What are signs I may need to replace it?
Clunking or knocking from the suspension over bumps, loose or wandering steering, and uneven tire wear can indicate a worn control arm or ball joint. Diagnose the cause before replacing.
Write a Review
MEVOTECH
Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS401262
Suspension Control Arm and Ball Joint AssemblyMevotech Supreme Parts™ are engineered in-house, with application-specific upgrades for increased durability and performance. Mevotech Supreme control...
Suspension Control Arm and Ball Joint AssemblyMevotech Supreme Parts™ are engineered in-house, with application-specific upgrades for increased durability and performance. Mevotech Supreme control...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
